乌苏不锈钢混流泵-泰安金石泵业公司-不锈钢混流泵供应价

无法启动

首先应检查电源供电情况：接头连接是否牢靠；开关接触是否紧密；***丝是否熔断；三相供电的是否缺相等。如有断路、接触不良、***丝熔断、缺相，应查明原因并及时进行修复。其次检查是否是水泵自身的机械故障，常见的原因有：填料太紧或叶轮与泵体之间被杂物卡住而堵塞；泵轴、轴承、减漏环锈住；泵轴严重弯曲等。排除方法：放松填料，不锈钢混流泵供应商，疏通引水槽；拆开泵体清除杂物、除锈；拆下泵轴校正或更换新的泵轴。

4、注意填料的冷却情况，填料的的调整，不锈钢混流泵供应价，不可太紧，以液体能一滴一滴漏出为准，填料太紧发热、消耗功率。填料太松、使水泵中的液体漏损过多，降低效率。

Pay more

attention to the cooling condition of padding.The padding can not be too tight，乌苏不锈钢混流泵，

it is ok that the fluid can leak in drops.The temperature will be high if the

padding is too tight which cumes power.If the padding is too loose，不锈钢混流泵采购价， the

fluid leaks too much， the efficiency will be lower.

2、水泵起动后有一股水就不出水了

After starting ，

the pump only send one stream water then no water runs out

1、吸入的水中有过多气泡

2、吸水管中窝存空气

3、吸水管或连接处垫料不严密有进气现象

4、底阀或叶轮有水草杂物填塞

1.There are too many bubbles in the

indrawn water

2.There is air in the suction pipes

3.The paddings in connected parts are

imprecision and produces leaking phenomenon

4.There are waterweeds and sundries

filled in the bottom valve or impeller

1、检查进水管末端是否在水平面以下一米左右

2、排除空气

3、高速垫料，填塞缝隙拧紧螺栓

4、消除水草杂物

1.Check the end

of water inlet pipe if it is under the water surface at one meter

2. Remove the

air

3.Add padding to

fill the gaps and then tighten the bolts

4.Clear the

waterweeds and sundries.