大流量混流泵厂家源头直供厂家 泰安金石泵业有限公司

混流泵

使用与***：Use And

Maintenance

1、经常检查轴承温度，轴承箱内应装70%的钙基黄油，不得过多或过少，轴承升温一般不得比周围超过35°C，轴承的极限温度不得超过75°C（用手摸感到烫手），若超过应停车检查原因予以消除。

Check the bearing temperature

regularly.The bearing box should be put 70% butter,it can not be too much or

too little.The temperature rising of bearing can not be more than 35°C higher

than around temperature and the limiting temperature of bearing is 75°C,if the temperature is higher than 75°C, stop to check the reason and adjust it.

注意功率是否突然增大或降低，流量扬程是否突然减少，如有应停车检查。

Pay more attention

to know if the power suddenly increases or reduces, if the flow and head are

suddenly lessen, if it is, pls stop to check.

3、经常注意检查各部分螺丝是否因振动而松动，如松动应随时上紧。

Check all parts

screws if they are loose, tighten them after finding.

5、泵运转时注意有无杂音及泵内是否有剧烈的磨擦和撞击声，如有就停车检查。

When the pump is

running, pls pay more attetion on the noise and friction and clashing noise, if

there are strong noise, pls stop the pump to check.

6、检查进、出水管路有无进气漏气现象。

Check the

water-in and out pipes if they are leaking air.

7、如电机与水泵为直联传动，需检查电机与水泵的轴心线是否在同一直线上，以防转时振动。

When the motor and pump are direct

connected drive ,check the motor and pump axile lead if they are in the same

line to ***oid vibrating.

8、水泵在冬季使用时，停车后应将水泵内和管道内的存水放尽以防冻裂。

If use the pump

in winter, pls run off the water from the pump and pipes.

9、水泵每使用一个灌溉季节后，应更换润滑黄油后存放。

Replace the

lubricating oil after using the pump for one irrigation season.

10、水泵工作满500小时，应仔细拆卸检查零件的磨损情况，如长期停用，应将运转部分拆下擦干上油妥善保管。